Frequently Asked Question

eTest verify or add station to a testing session

Note there are no stations attached to the testing session.

Step 1: On testing,station select "Take a Test"

Step 2: Double click the CasasWebTests .exe to launch the testing session

Step 3: Select "Run" To launch the full screen client

Step 4: Select "Register station with code"

Step 5: Enter the Station Registration Code from the Session activity window.  The code changes with each session start so do not use the code in the images shown here.

Step 6: You will be notified of successful registration Select "OK"

The station will now show up on the session activity window.

The station is now available in this session for testing until you end the session.  Once the session is ended the station is wiped from the session and you will need to complete the above steps again when you start the session.

For remote testing, if this was your setup process, you can now select "Exit" to close the test session, you will be able to relaunch the test session on the testing machine without needing to register it again.  At this point,you are ready to initiate the zoom call to the student.